Keeguard® Standing Seam

KeeGuard® Standing Seam Railing with Gate

KeeGuard® Standing Seam Railing with Pipes

Keeguard^® Standing Seam

Request Quote

KeeGuard® Standing Seam Railing is an OSHA Compliant roof edge fall protection system that prevents workers and other personnel from falling off of roofs with standing seams. Metal plates clamp onto the standing seam using S5U aluminum clamps. Railing posts are bolted to the plate, and top and mid rails are installed between the posts. The railings extend above the walking surface 42” and withstand a force of 200 pounds. Custom Colors are available.

Its configuration accommodates varying angles, circular configurations, ladders and rooftop obstructions. KeeGuard® Standing Seam Railing System complies with OSHA Standards 29 CFR 1910.23 and meets North American and Canadian requirements.

Features:

OSHA compliant design

Clamps to Standing Seam roofs without roof penetrations

Accommodates varying angles, ladders and rooftop obstructions

Custom fabricated base plates accommodate any standing seam width

Infill Panels are available

Kick Plates are available

Materials:

Posts, top and mid rail pipe is ASTM A53 1-1/2-inch schedule 40 galvanized steel

Fittings are galvanized Kee Klamp® malleable iron-type

Base fittings are galvanized steel with galvanized mounting plates

Aluminum S5U clamps fasten plates to roof

Finish for pipe, handrails, mid-rails, uprights and base plates are a galvanized mill finish to ASTM A53 requirements

Kee Klamp® type 69 base fitting is used when toe plates are required

Installation:

Four S5U clamps are bolted to galvanized steel mounting plates

Mounting plate assemblies are attached to the standing seams

Kee Klamp® Type 62 base fitting is attached to each metal mounting plate to support the galvanized upright posts assemblies

Upright post assemblies are inserted into the Type 62 base fitting

Galvanized top and mid railings are saddled between posts

Note: 3 workers can install greater than 300 linear feet of railing in a day. Shop drawings can be provided if needed.