Call Us (877) 723-3766

FAX (610) 539-1630

Type 28 - Two Socket Custom Cross

Usually used for guardrailing on a slope, between the mid-rail and an intermediate upright which is required to remain vertical. These fittings are held in stock as blanks which are machined to individual requirements. It is therefore, essential that when ordering, the required angle is stated. Note: When Type 28 fittings are used in pairs (i.e. on stairs or ramps), they will not be handed. The set screws on one side will therefore face inwards on the stair or ramp. For an alternative to this fitting, see Type 30. Weights given in the table are for blank fittings.